(Every Device requires driver utility to set active
Insert Driver CD and install software for the above Device. UNKNOWN DEVICE FOUND May the Driver utility is not provided with operating system.
The Standard setting for Windows is set it to 800圆00 for better performance.Ģ8. Configure Display Card properly with their CD. Final solution is to Reinstall Operating System.Ģ7. WINDOWS REGISTRY ERROR This will happen due to sudden ON/OFF of the system. (This procedure will not make any effect on existing Data).Ģ6. OR Reinstall Windows 98 Operating System. Make available above files from other Computer. MMX/DLL FILE MISSING May the above files may be corrupted due to power failure or Virus. For Eg: Hard Disk formatted with Pentium System will hide their partitions for 486 System.Ģ5. PARTITION NOT SHOWN Operating System where the Hard Disk formatted is not supported with present Mother Board. If found format the Hard Disk and set Partition before that area.(This is the only procedure to use Hard Disk with Bad Sector) OR (To avoid Bad Sectors use Standard Power Supply)Ģ3. HARD DISK HANGS WHILE PROCESSING Check for Bad Sector by using CHKDSK or SCANDISK Command. It may create Bad Sector OR Weak Hard Disk.Ģ2. HARD DISK MAKING NOISE WHILE PROCESSING a. Use CHKDSK/F or SCANDISK Command to correct it.Ģ1. May some Directories or Files crash with other files. Operating system used for formatting is not validĢ0. The type of Hard Disk in CMOS may not be set properly. MISSING COMMAND INTERPRETOR May the file is corrupted OR Infected by Virus OR Some one has Erased it.Ī. These above three files required for Start up of the system that can be transferred by using SYS C: Command OR While the time of formatting by using Format c:/u/sġ8. MISSING OPERATING SYSTEM The System files missing namely Ie } - User File IO.SYS & MS_DOS.SYS } - Hidden Files. Floppy Drive having different disk (Non-Bootable Disk) OR CMOS Parameters for Hard Disk may not be set properly. Software problem (due to using pirated software) d. MOTHER BOARD HANGS DUE TO UNSTABILIZED POWER SUPPLY a. Check Hard Disk parameters in CMOS or Auto detecting Setting Partitions by Fdisk Command, then format it to set track 0.ġ2. SHOWING HDD ERROR OR HARD DISK FAILURE a. SHOWING FDD ERROR OR FLOPPY DRIVE IS NOT WORKING PROPERLY Check Power cord of FDD, Data Cables, set CMOS & Finally the Check drive.ġ1. Set Original Settings Manually.(Refer CMOS Setup chart) Enter your search termsSubmit search formġ0. SHOWING CMOS ERROR Replace 3 Volt battery of Mother Board. Connect rightly seeing the Red mark (Faces power supply) and then Restart.Ĩ. NO DISPLAY ON THE SCREEN AT ALL Hard Disk cable connected wrongly.
FDD LED IS GLOWING CONTINUOSLY Data cable to be connected properly (twisted cable).ħ. CONTINUOS NON-STOP BEEPING Key Board Problem (I.e. THREE LONG BEEPS PERIOD WISE Problem in BIOS or RAM (Basic Input Output System)ĥ. THREE BEEPS ( 1 Long 2 Short) Problem in Display Card ConnectionĤ. CONTINUOS THREE BEEPS Problem in RAM Connection.ģ.
MONITOR LED IS BLINKING Check all the connections like Monitor Cable, Data cables,RAM, Display Card, CPU connections.Ģ.